How to install mesh belt normalizing furnace

The mesh belt normalizing furnace is simple in structure, low in cost, and has a good cooling effect on the workpiece. Mesh belt normalizing furnace The technical solution of this technology is: a mesh belt normalizing furnace, including a furnace body, the furnace body is equipped with a horizontal transmission mesh belt, the mesh belt is reciprocated between two transmission rollers, and the furnace body is provided with a horizontal transmission mesh belt. The workpiece is placed on the feed inlet of the mesh belt. The furnace body is provided with a cooling device at the outlet of the mesh belt. The cooling device includes a mesh belt shield. The mesh belt shield is provided with front and back sides respectively exhaust fan. Preferably, the exhaust fan on the front side and the exhaust fan on the back side are staggered and distributed along the transmission direction of the mesh belt. Preferably, a driving roller is provided in the middle of the two transmission rollers, the driving roller is driven by a motor, and the left and right sides of the driving roller are respectively provided with tensioning wheels.

After checking that the wiring is correct, you can turn on the power. First, turn on the power switch, and then pull the button switch on the controller panel to the open position, and set the temperature to your desired setting. For the required degree, if the setting switch is pulled to the measurement position, the red light is off (NO), there is also the sound of the contactor, the electric furnace is energized, the ammeter indicates the heating current value, and the temperature gradually increases with the increase of the temperature in the furnace. When the temperature rises to the required temperature, the red light is off (NO), the green light is on (YES), the electric furnace is automatically powered off, and the temperature is stopped. Later, when the temperature in the furnace drops slightly, the green light Turns off, the red light is on, and the electric furnace is automatically energized. The cycle repeats to achieve the purpose of automatically controlling the temperature in the furnace.

The high-quality insulation material is used as the insulation layer between the furnace and the furnace shell. The muffle furnace is generally applicable to various industrial and mining enterprises, laboratories, and scientific research units. The gap at the device hole is blocked with asbestos rope, only the connection method needs to be changed, and after the connection method is changed.

The main feature is that the periodic energy-saving operation furnace can reach 1200 degrees and is convenient to use. Here I will tell you about its characteristics. The main structural feature is that it is connected to the rail and does not need to be installed. As long as it is transported to the destination, it is placed flat. On the ground, it is OK to fix it. This is the main feature of the trolley furnace, and his mass production technology can be said to be one of the best, the efficiency and quality are guaranteed, and the high-power generator can make the efficiency high and the quality is good, causing a lot of Businesses use it. Energy-saving full-fiber trolley furnace. The shell of this series of electric furnaces is welded by steel plate and section steel. The bottom of the furnace body is connected with the light rail of the trolley. The user does not need basic installation, but only needs to be placed on a flat concrete floor. Ready to use.

The experimental electric furnace does not need special installation, it only needs to be placed flat on the indoor floor or bench. The controller should be placed on the workbench, and the inclination of the work surface should not exceed 5 degrees. The distance between the controller and the electric furnace should not be less than 0.5 meters. The controller should not be placed on the electric furnace, so as not to affect the normal operation of the controller.